Located in Thornton, Serving Thornton and Surrounding Areas.
Rewiring Thornton homes mostly comes down to two eras. The first houses here went up in 1953, when Sam Hoffman started building small ranches off Washington Street, and plenty of them still run on the two-wire circuits they were built with. Then came the late 1960s and 1970s boom north of Thornton Parkway. Modelco Electric is based in Thornton and has been doing this work since 1993.
Some calls turn into a whole home rewiring. Others turn out to be three bad circuits and one scorched outlet. We find out which one you have before anyone writes a number down.
The original Thornton subdivisions were built fast and built cheap, which is not an insult. It is how a young family got a three-bedroom house in 1955. The wiring from that era is two-conductor cable with no ground. Over seventy years, somebody usually swapped the two-prong outlets for three-prong ones with nothing connected to that third hole. It looks fine. It protects nothing. Rewiring Thornton ranches from that era means grounded cable to every outlet, GFCI protection where code calls for it, and no more splices buried behind the drywall. Our rewiring crew works room by room so the house stays livable.
Thornton grew quickly in the late 1960s and early 1970s, right when copper prices pushed some builders to aluminum branch circuits. The wire itself is not the problem. The connections are. Aluminum expands and contracts more than copper, terminals loosen, and a loose terminal gets hot. It is one of the most common reasons for rewiring Thornton houses from that decade. If you see dull gray wire behind a switch plate, or outlets that feel warm, book a wiring inspection before anything else. Then you choose between full replacement and copper pigtails on every connection.
Most of Thornton was built after knob and tube went out of use, so we do not find it often. The exceptions are the old farmhouses that got surrounded by subdivisions and the early houses around Eastlake. When we open a wall and see porcelain knobs, knob and tube wiring replacement goes to the top of the list. The insulation on those conductors is brittle by now, and somebody has almost always blown attic insulation right over it. We handle those jobs as retrofit work, fishing new cable through the existing walls instead of tearing them open.
Most Thornton ranches give us an attic above and a basement or crawlspace below, which makes residential rewiring a lot less messy than people expect. We drop new runs from the attic, pull them up from the basement, and cut small access holes only where a fire block or header gets in the way. Those holes get patched before we leave. If your service is still the original 60 or 100 amps, pair the rewire with a panel upgrade so the new circuits have somewhere to land. One permit, one cutover, one inspection.
Not ready for the whole house? Our repair service can fix the circuit acting up today, and we will flag the rest so you can plan for it.
Modelco is a Thornton company. The business dates to 1993, and owner Matt Moody has more than twenty years in the trade. We are licensed and insured, there are five of us, and the person who quotes your rewire is on the job when it happens. If you searched house rewiring near me from a house off 104th or Thornton Parkway, our shop is probably closer than the first result that came up. Rewiring Thornton homes is everyday work for us, because we live with the same housing stock you do.
We work all over the north metro: Northglenn and Federal Heights to the west, Westminster across Federal Boulevard, Commerce City to the south, and Brighton out past E-470. We do the same work in Brighton's older neighborhoods and in the 1950s ranches of Broomfield Heights. Anyone in the north metro looking up house rewiring near me reaches the same five people.
Often just a few. A lot of Thornton ranches had a kitchen or bath redone at some point, and those circuits are fine. What usually needs replacing is the original bedroom and living room wiring. We test each circuit, look in the attic and basement, and tell you which runs are worth keeping. A full rewire only makes sense when most of the house is the same tired cable.
For a typical single-story ranch with an open basement ceiling, plan on a few working days. A finished basement, plaster walls, or a two-story layout adds time. We cut over one circuit at a time, so most of the house keeps power through the job, and you get a day-by-day schedule before we start.
No. Families stay home for nearly every rewire we do. Expect some circuits off during the day, furniture pulled a couple of feet from the walls, and small openings in drywall that get patched before we leave. Bedrooms are back on every night.
Aluminum branch wiring from the late 1960s and early 1970s is a known fire risk at the connections, not along the wire runs. Outlets and switches loosen over decades of heating and cooling. You can replace the wiring or have every connection pigtailed to copper with approved connectors. In Thornton houses from that era we check for it on every walkthrough.
The City of Thornton building inspection division issues the permit and does the inspections. We pull it, schedule the rough-in and final inspections, and meet the inspector. You get the signed-off paperwork when the job is done, which you will want when you sell or when your insurer asks.
Yes, and on older houses we usually recommend it. A 60-amp or 100-amp panel from the 1950s rarely has room for the circuits a modern rewire adds. Doing both under one permit saves a trip, a second inspection, and a second power shutoff.
It depends on square footage, circuit count, access through the attic and basement, wall finish, and whether the panel stays. We do not quote rewires over the phone. After a walkthrough you get one itemized price covering labor, materials, the permit, and drywall patching.
It usually does. Some insurers ask about wiring type and age, and buyer inspections flag ungrounded outlets and aluminum circuits every time. A permitted rewire with a final inspection on file takes that item off the negotiating table.
Tell us what you are seeing. Warm outlets, flickering lights, two-prong outlets, a breaker that trips when the microwave runs. We will open a few boxes, check the attic and basement, and give you a written quote for electrical rewiring services that covers the permit and the patching. Schedule a visit and we will call you back the same day. Rewiring Thornton houses is home-turf work for us, and we will tell you straight if a repair is all you need.
We're based right here in Thornton, CO. That's our home base — but we also serve nearby areas throughout the region. If you're in one of these communities and looking for a reliable electrician in the Thornton, CO area, we're glad to talk through your project.