Located in Thornton, Serving Thornton and Surrounding Areas.
Rewiring Broomfield homes usually starts in the original part of town. Broomfield Heights went up in the mid-1950s beside the new Boulder Turnpike, rows of modest ranches along Midway Boulevard and the streets around it, and many still carry wiring from that first build. Modelco Electric has done this work since 1993, and we know these floor plans well.
Newer parts of town like Anthem rarely need a rewire. The 1950s and 1960s neighborhoods are where we spend our time.
The first Broomfield Heights houses were wired for a radio, a refrigerator, and a few lamps. Now those same circuits carry a home office, a microwave, a window AC unit, and a charger in every outlet. The cable is ungrounded, the insulation in the attic has gone brittle, and the outlets do not hold a plug anymore. Rewiring Broomfield ranches like these means grounded circuits throughout, GFCI in the kitchen and baths, and capacity where the family actually uses it. Our rewiring service works from the attic and crawlspace to keep wall openings small.
Houses from this era often came with Federal Pacific Stab-Lok or Zinsco panels, and both brands have a long record of breakers that fail to trip. Old panel plus old wire is the combination that worries us most. When we rewire, we almost always recommend a panel replacement at the same time, so the new circuits sit behind breakers that work. Same permit, same inspection, one power shutoff.
Not every job here is a whole house. Plenty of owners are redoing a kitchen or finishing a basement, and the inspector will not let new work tie into ungrounded cable. That forces a decision about the rest of the circuit. We rewire what the remodel touches plus the runs feeding it, then give you a clear picture of what is left. Staged residential rewiring like that spreads the cost over a few years. When an addition or a converted garage needs circuits brought up to current code, that falls under our retrofitting work.
Since 2001, Broomfield has been a combined city and county, so every address goes through the same building division, whether you are in Broomfield Heights, Westlake, or out by Interlocken. Rewiring Broomfield properties is simpler to permit than in towns that straddle county lines. We pull the permit, schedule the rough-in and final, and meet the inspector. Buying an older house and want to know what is behind the walls first? A pre-purchase wiring inspection answers that before you close.
Modelco has been the same company since 1993. Matt Moody owns it, has more than twenty years in the trade, and still shows up on jobs. We are licensed and insured, and you deal with the people doing the work from the first walkthrough to the final inspection. Our Thornton shop is a straight shot west on 120th Avenue, so if you searched house rewiring near me from somewhere off Midway, the drive is short. Rewiring Broomfield houses keeps us on that road most weeks.
Beyond Broomfield we work in Westminster, Superior, Louisville, Lafayette, Erie, and Northglenn. East of I-25 we take on rewiring in Thornton all the time, and out on the plains we handle older homes in Brighton with original plaster and wiring. Anyone looking for house rewiring near me across the north metro and Boulder County reaches us at the same number.
Rarely. Broomfield Heights was built in the 1950s, after knob and tube had mostly gone out of use. What we find instead is ungrounded two-wire cable and old panels. If your Broomfield house predates the subdivisions, like an old farmhouse, it is worth checking, and knob and tube wiring replacement would come first.
Not necessarily. New basement circuits get their own runs from the panel. The issue comes when the plan ties into existing ungrounded circuits or the panel has no open spaces. We look at both before you frame.
Both have a documented history of breakers that do not trip under overload. Not every one fails, but we do not recommend keeping one in service, especially behind fresh wiring.
The City and County of Broomfield building division. Every Broomfield address goes through the same office, so there is no question of county lines. We pull the permit and handle both the rough-in and final inspections.
Yes. We switch circuits over one at a time, so most of the house has power on any given day, and bedrooms are back on at night. Furniture moves a couple of feet from the walls and goes back when we finish.
Warm switch plates, outlets that will not hold a plug, lights that dim when the fridge kicks on, a burning smell, or breakers that trip for no clear reason. Any of those deserves a look. Some turn out to be a single bad connection we can fix in an afternoon.
Sometimes. Buyers in Broomfield see ungrounded outlets and old panels flagged on inspection reports, and those items turn into price cuts. A permitted partial rewire of the worst circuits can cost less than the credit a buyer asks for.
After a walkthrough. House size, circuit count, access, wall finish, and panel condition drive the number. The written quote lists labor, materials, the permit, inspections, and patching, so nothing shows up later.
Tell us the year your house was built and what is bothering you. We will look at the panel, the attic, and the outlets, and give you a straight answer on whether you need electrical rewiring services or just a repair visit. Rewiring Broomfield homes starts with that one walkthrough. Set up a time and we will call you back the same day.
We're based right here in Thornton, CO. That's our home base — but we also serve nearby areas throughout the region. If you're in one of these communities and looking for a reliable electrician in the Thornton, CO area, we're glad to talk through your project.