Rewiring in Longmont, CO

Rewiring Longmont Houses on Both Sides of Main Street

Rewiring Longmont houses starts with knowing which Longmont you are in. The East Side and West Side historic districts flanking Main Street are full of Victorians and Craftsman bungalows with original wiring layered under decades of upgrades. Out past Hover, the subdivisions from the 1970s on carry their own problems. Modelco Electric Corp has been doing home rewiring since 1993, and the approach changes with the house.

One thing every job here has in common: your power comes from Longmont Power and Communications, not Xcel. That changes how we schedule a shutoff, and it is the kind of detail a crew from out of town finds out the hard way.

Knob and Tube in Longmont's East Side and West Side Historic Districts

The older homes on streets like Collyer, Pratt, and Kimbark were wired for a few bulbs and a radio. Since then they have picked up window units, a dishwasher, a basement bedroom, and a home office, mostly by extending whatever was already there. Knob and tube replacement in these houses means pulling new grounded copper from a modern panel to every room and abandoning the old runs safely. Plaster and lath slow the fishing down, so we plan access from the attic and basement and keep wall openings to a minimum. Here is how our rewiring service lays out a phased plan if you want to stage the work.

Coordinating a Longmont Rewire With LPC Instead of Xcel

When a rewire includes a new service or panel, the utility has to disconnect and reconnect. In Longmont that is LPC, the city-owned utility. We line up the disconnect, pull the City of Longmont electrical permit, and get the inspection signed off so LPC can restore power the same day where possible. A lot of the old houses here still run on 60 or 100 amp services, so a service and panel upgrade often rides along with the rewire. Doing them together saves you a second shutoff.

Basements Along the St. Vrain and Wiring That Took on Water

The 2013 flood put water in a lot of Longmont basements near the St. Vrain. Some were dried out and rewired properly afterward. Some were dried out and left alone. Wiring that sat underwater can corrode inside the jacket, and breakers that got wet are not to be trusted. If you bought a house near the river and nobody can tell you what was done, an electrical inspection answers it. Sometimes the result is a basement rewire. Sometimes it is a repair of a few circuits and a new set of breakers.

Aluminum Wiring Replacement and Whole House Rewiring in Longmont Subdivisions

Plenty of Longmont houses went up in the late 1960s and early 1970s, and a share of them have aluminum branch circuits. Loose, oxidized connections at outlets and switches are the risk. We either swap the branch circuits for copper or repair each termination with connectors rated for both metals, and we price both. Where the wiring is a mix of eras and patch jobs, a full rewire is often simpler than chasing problems one at a time. While the panel is open, surge protection is worth the small add. Rewiring Longmont houses of this age usually goes faster than the historic districts, since attics are open and the walls are drywall.

Longmont Rewiring Cost Comes Down to Walls, Attic, and Access

No two rewiring cost estimates here look alike. Plaster or drywall, attic clearance, a finished basement, the number of circuits, and whether LPC needs a service disconnect all move the number. We walk the house, then hand you one itemized figure covering labor, materials, permit, and inspection. If you would rather spread it out, room-by-room rewiring is an option, and rewiring Longmont homes in phases works fine as long as the circuit map is done first.

Why Longmont Owners Trust a Small Crew That Has Kept Its Name Since 1993

Modelco has operated under the same name since 1993. Owner Matt Moody has better than twenty years as an electrician, the company is licensed and insured, and there are five of us. You will not get a call center. You get the person who quoted the job, and that person shows up. Longmont people tend to be practical about this sort of thing, and rewiring Longmont houses is exactly the kind of work where knowing who is in your attic matters.

Rewiring Beyond Longmont in Niwot, Firestone, Mead, and Lyons

We also cover the towns around Longmont: Niwot and Gunbarrel to the southwest, Firestone and Frederick to the east, Mead and Berthoud to the north, and Lyons and Hygiene toward the foothills. South on 287, our rewiring work in Lafayette and Louisville house rewiring come from the same crew. Anyone searching house rewiring near me in this part of Boulder County reaches the same phone.

Common Longmont Rewiring Questions

Does it matter that Longmont has its own power utility?

For a rewire that touches the service, yes. LPC handles the disconnect and reconnect, not Xcel, and the city inspection has to clear before power is restored. We coordinate both so you are not stuck on the phone with the utility.

Can you rewire a house in Longmont's historic districts without wrecking the trim?

My basement flooded in 2013. Is the wiring still a concern?

How can I tell if I have aluminum wiring?

Do I need a permit to rewire in Longmont?

Will the power be off for days?

Do you rewire farmhouses outside Longmont city limits?

Can a rewire fix lights that dim when the furnace kicks on?

Book a Longmont Wiring Assessment

Give us the address, the year the house was built, and what made you call. We will walk it, check the service, and write up the plan for rewiring Longmont homes like yours, with the permit and LPC coordination included. If house rewiring near me is what you typed to find us, you are in the right place. Send a request and get a callback the same day.